Unsolved

This post is more than 5 years old

5 Posts

55184

August 12th, 2006 14:00

2407WFP buttons NOT working! (can't unlock either!)

I got the 24" 2407 3 days ago, worked fine upon connected and turned on for less than an hour. Yesterday I put a DVD to watch on the PC, and about an hour into the movie, the OSD menu showd up all on its own and when I tried pressing the Menu button to unload it a big LOCK appeared in the center of the screen.

Since then, absolutely none of the buttons are working. Not the Signal selection button, not the PiP/PbP button, not the MENU button, not the "-"/"+" buttons, and worst of all, the POWER button! I already tried everything I read, 15 seconds holding the Menu button to unlock doesn't work either. It seems as if the whole button panel is locked with no way to unlock it.

Is this a known issue? Is there a way to fix it? Is the Monitor faulty?

5 Posts

August 12th, 2006 18:00

No message indicating a lock appear. The only time it did it was just before the buttons stopped answering. It was not a message either, just a big padlock icon in the middle of the screen.

I tried pressing the "-" and "+" buttons, the "Menu" and "+" buttons, the "Power", all shortly and for a period of time, yet they don't answer. None of them do anything, and the screen is stuck at "ON", since I can't turn it off other than unplugging it. To have it take another signal input, I have to disconnect all but the one I want it to take and unplug-replug. Console is completely out. Light on Power button works normally: Green when on, Orange when it enters power saving mode.

This screen does not have channel up/down or sound up/down buttons, just the "-" and "+" which are for Menu operation I believe. Nonethless, I tried what you said to no avail.

Community Manager

 • 

56.9K Posts

 • 

232.1K Points

August 12th, 2006 18:00

Kooey1,

Try this and let me know the results -

* A message appears stating that the OSD and buttons are locked
* Press the volume decrease and channel up buttons on the monitor simultaneously
-or-
* Press the channel up and volume increase buttons on the monitor simultaneously
* A message appears stating that the OSD and buttons are unlocked

3 Posts

August 13th, 2006 00:00

I have the same lack of front controls on my 2007 FP (Wide). The only way to turn the monitor off is by unplugging.

3 Posts

August 13th, 2006 00:00

I just succeeded in unlocking the controls on my 2007 FP by holding the plus and minus buttons in for about 20 seconds simultaneously.

5 Posts

August 13th, 2006 01:00

I just wish I had your luck, I believe I held them both for over a minute but it remains locked =(

1 Message

August 13th, 2006 03:00

Same problem here, can't find the documentation for this ANYWHERE on the dell site. After reading your post I pressed and held my menu button for ~20-30 seconds on 2007FPW a00 and it removed the lock.

Good luck,

Scott

Message Edited by coscharlie on 08-12-200611:11 PM

1 Rookie

 • 

9 Posts

August 26th, 2006 01:00

The same happened to my dad's 15" lcd monitor.

None of the buttons responded and then he got a big padlock blinking on the screen.

The only way I got it to go away was by changing the screen's resolution. I posted step by step instructions on this page.

http://www.paulstravelpictures.com/Dell-LCD-Monitor-Flashing-Padlock-Icon/index.htm
No Events found!

Top