Cannot bind socket to connection port in configured port range on system

Question

Hi,

I'm getting an error on the backup server "nsrmm: Cannot bind socket to connection port in configured port range on system ". i also get an error "winworkr: Cannot bind socket to connection port in configured port range on system .

Now I can connect to the server from another server on NMC. The server is w2k3 running NW731.

Does anyone know how to resolve this?

Tks,
Liam

ble1 · Answer

Increase connection port range. It might be you have used all ports (I have seen that when running Oracle restore which needs to wait), but more likely is that your range is too small or blocked by something else (eg. firewall).

ble1 · Answer

From CLI you can run nsrports to see your current port settings. Since you have 7.3.1 (yuck) it is possible that connection ports are not limited, but perhaps you are using some older settings so you need to check that. To change it you can use also nsrports command.

lguinane · Answer

I do not know how to do this. Is it explainable?

NetWorker

Cannot bind socket to connection port in configured port range on system

Was this post helpful?