7.4.4 is pretty old and as far as i remember it did not have a client configuration wizard !
Have you considered updating/upgrading your data protection infrastructure to a supported version as neither Windows 2003 not NetWorker 7.4.4 are currently supported.
As for the above error i suspect your are using a later version of NMC and are trying to launch the client configuration wizard. Is your NMC installed on a different system? If Yes, what is the version of the NMC that you are using ?
In order to use the client wizard you need Networker version 7.5.1. Also as already noted by CrazyRov, both your Networker version and Windows 2003 are out of support with EMC and Microsoft.
Regarding Networker Server versions and NMC, versions are, as shown in the following figure:
Now, I understand that it is an outdated version but is licensed, and that is something that a company public is necessary, something which they have been working and I can not change (at least until the budget of 2017, at least) so I have to adjust myself to what I have, any extra help?
Hello Danag. I can perform with the Client Wizard adding new customers, however with the client indicated (lima3) get the error that indicated (attached picture); This despite the fact that at some time the agent was installed and worked without problems:
As I mentioned in a previous answer, I can not change the version, a matter of budget and licenses, so I have to work with what I have.
crazyrov
4 Operator
•
1.3K Posts
0
August 8th, 2016 22:00
7.4.4 is pretty old and as far as i remember it did not have a client configuration wizard !
Have you considered updating/upgrading your data protection infrastructure to a supported version as neither Windows 2003 not NetWorker 7.4.4 are currently supported.
As for the above error i suspect your are using a later version of NMC and are trying to launch the client configuration wizard. Is your NMC installed on a different system? If Yes, what is the version of the NMC that you are using ?
danag2
20 Posts
0
August 10th, 2016 04:00
In order to use the client wizard you need Networker version 7.5.1. Also as already noted by CrazyRov, both your Networker version and Windows 2003 are out of support with EMC and Microsoft.
pierre_pandur
3 Posts
0
August 10th, 2016 07:00
Regarding Networker Server versions and NMC, versions are, as shown in the following figure:
Now, I understand that it is an outdated version but is licensed, and that is something that a company public is necessary, something which they have been working and I can not change (at least until the budget of 2017, at least) so I have to adjust myself to what I have, any extra help?
Thanks,
Pierre P.
pierre_pandur
3 Posts
0
August 10th, 2016 08:00
Hello Danag. I can perform with the Client Wizard adding new customers, however with the client indicated (lima3) get the error that indicated (attached picture); This despite the fact that at some time the agent was installed and worked without problems:
As I mentioned in a previous answer, I can not change the version, a matter of budget and licenses, so I have to work with what I have.
I appreciate your comments.
ble1
4 Operator
•
14.3K Posts
0
September 21st, 2016 03:00
Instead of wizard, configure it manually.