Unsolved
This post is more than 5 years old
7 Posts
0
1808
September 19th, 2007 11:00
error message: "read open error: The system cannot find the file specified.
Getting the following message while trying to label tapes. I know we have a driver mis-match issue (read the below post on cloning issue) but this is new. Any idea what this is, or what file it's complaining about not finding?
No Events found!
amediratta
2 Intern
•
2K Posts
0
September 19th, 2007 11:00
This error comes in when the drive is not poreply configured on the OS or the device path name selected in NW configuration is not valid.
ble1
4 Operator
•
14.3K Posts
0
September 20th, 2007 06:00
rtpani1
1 Rookie
•
28 Posts
0
September 27th, 2007 03:00
This message is seen in Networker. Mostly if you have mis-configured devices then this message is seen. If your setup has tape library & multiple drives, then there may be chance that your device mapping at OS side might have changed & old working configuration in your networker server becomes invalid. So check for the device listing at OS end first & check if you have configured appropriately in the networker server.
Regards,
R.Thandayuthapani