NetWorker
Posts
This post is more than 5 years old
Solved!
Go to Solution86 Posts
0
9638
September 28th, 2009 05:00
NetWorker and the inquire command are not seeing the ADIC Scaler 24 Jukebox
Responses(18)
7
0
2
91
0
8
30
0
2
15
0
3
37
0
2
No Events found!
pereubu
86 Posts
0
October 6th, 2009 04:00
Firstly, Yes there is problem with HBA. One HBA is with one target which is supossed to be with pesistent binding, but no path is included - it is empty. No automapping as well. On servers which can operate with a jukebox, the path are included to
Well, persistent path naming seems to be OK. I have come accross several white papers from emc and MS as well. At the end of reading some of them I was completely confused. The installed drivers were native, and I did as well for IBM Ultrium for new server nodes (There is only one device driver for Tape1 in Device Manager). "The company" did poor job in installation and administration of SAM system in my company. I do not have power and authority to change what they have done.
Tape Drivers in Device Manager are (for all severs) Tape0 and Tape1:
ibmtp2k3.sys
ibmtpft2k3.sys
ntutil.exe (what is that?)
For new server: only Tape0 (driver detail same, I mean driver files). I have to install driver for IBM Ultrium TD3.
Message was edited by:
DoleBludger
HacknDos1
66 Posts
0
October 6th, 2009 08:00
So, here is my simple little test if in fact each drive is zoned to a different HBA. The HBA with the drive that is working, zone the drive that isn't working to that HBA and see if it appears correctly then.
pereubu
86 Posts
0
November 30th, 2009 03:00