Unsolved
This post is more than 5 years old
5 Posts
0
533
June 19th, 2006 22:00
NW 7.3 Problem when installing recovery manager on NT
I tried to install NW 7.3 and NRM 1.02 on Windows NT SP6a
Using Networker backup and recovery everything fine but NRM show error box when install and try to run drmconfig.
drmservice.exe Entry point not found.
the procedure entry point getlocalhost could not be located in dynamic link library liblocal.dll
Using Networker backup and recovery everything fine but NRM show error box when install and try to run drmconfig.
drmservice.exe Entry point not found.
the procedure entry point getlocalhost could not be located in dynamic link library liblocal.dll
0 events found
No Events found!
ksuwat
5 Posts
0
June 19th, 2006 23:00
Message was edited by:
suwat khaengraeng
ble1
6 Operator
•
14.4K Posts
•
56.2K Points
0
June 20th, 2006 01:00
- What NW versions are you using? 7.3? OK, that's fresh one (even you should go with 7.3.1).
- NRM 1.0.2? AFAIK that one is not been tested with 7.3 - only up to 7.2.1.
- NT SP6? Oldies but goldies, heh? Even it lists as supported client support, I would not hold my breath over that. I really think you should lower down your NW version for start.
So I would start with NW 7.2.1 or even 7.1.4 on that client and test it again. If it fails open this as support call with your support.