Unsolved
This post is more than 5 years old
4 Posts
0
5625
August 9th, 2011 10:00
nsrexecd SYSTEM error: Unable to register....
I've tried installing clients 7.5.1, 7.6.1 and 7.6.2 on a CentOS 5.6 box in our environment. We have plenty of other Red Hat and a few CentOS boxes backup up without a problem.
The install runs fine. When I start networker 7.6.1 or 7.5.1 there are no errors. When I start 7.6.2 there's a warning about the random number generator.
In any case, the nsrexecd process does not start, or immediately stops -- it's definitely not running long enough to see it in ps. The only error is in /nsr/logs/daemon.raw, which says the following:
nsrexecd SYSTEM error: Unable to register 390436 version 1 on tcp. Aborting
nsrexecd Cannot start authserver (or Cannot start authentication server for 7.6.2)
I'm not even sure where else to look for errors. There's nothing in the regular logs (/var/log) that's interesting.
I'm completely willing to downgrade or upgrade Centos, this box is just a file server so the version isn't important.
Also please note I'm not the networker admin, but I can yell at him from my cube if there are question about the overall system. All our other backups are running normally, so I'm pretty sure it's specific to this box.
bingo.1
2.4K Posts
0
August 9th, 2011 14:00
There should not be any issue. In your case, i would open a SR.
However, using an older NW version for the client is not an issue. So you have a workaround until the problem will be fixed.
36115_carloscor
217 Posts
0
August 10th, 2011 05:00
Hi there,
As a first step I would try to start up services in debug mode and check out the output.
What about if you run:
nsrexecd -D9
I think this could be a connectivity issue, or even a name resolution issue.
What about firewalls, is there any firewall in between NW server and clients?
Are the permissions ok? I mean OS/Domain and also the permissions for the binaries themselves.
Thank you.
Carlos.
no_neckbeard
4 Posts
0
August 10th, 2011 05:00
Sorry if I wasn't clear -- in ALL versions I've tried, the service will not start. 7.6.2 issues a warning at the console when started, and the others do not. However, none of them actually start the service.
Unfortunately I will probably have to rebuild the system and try it again or try a different OS if no one else has any ideas.
no_neckbeard
4 Posts
0
August 10th, 2011 06:00
Ah now there's an interesting command.
It may be a portmap or networking issue. Comparing the same command run on a known good installation (on RHEL 5), it seems to fail right after binding to the ipv4 socket.
The only other difference is that this machine doesn't have ipv6 enabled, and the working RHEL5 machine does. I can try enabling that for laughs, but it'll require a reboot and I won't be able to do that until after hours.
36115_carloscor
217 Posts
0
August 10th, 2011 06:00
You would like to check also the hosts file in the client.
Is IP_V6 enabled? I mean, is there any entry for IP_V6 in the hosts file?
Thanks.
Carlos.
no_neckbeard
4 Posts
0
August 10th, 2011 07:00
Holy moly you're my hero. The hosts file was hosed -- it only had the ipv6 loopback address (ipv6 wasn't enabled) and no 127.0.0.1 entry. I blame the CentOS installer
Fixed that and everything's aces. Thanks.