Unsolved
This post is more than 5 years old
1 Rookie
•
83 Posts
0
313
July 11th, 2010 18:00
Whether Cloning Need a Idle Driver？
hi,all:
I have two driver, one GROUP,when backup start,it will be used all the driver(2),and this GROIP is Set up for cloing,but when backup completed,Cloning does not run.This time two backup TAPE are in the driver, 5 minutes later They are Unload because i set the Device Eject Time,so all the driver is Empty.But even so, it have been waiting for cloning Without any warning,
thanks~
No Events found!
coganb
736 Posts
0
July 12th, 2010 01:00
Hi,
Look at the selection criteria for the clone pool that you are using to be sure that it is not too restrictive. You can also try cloning from the command line to test and this should give you an error message that will point you in the right direction. You should look up the NetWorker Command Reference Guide for the nsrclone command which gives all the detail you need with examples. You can find this on Powerlink at:
Home > Support > Technical Documentation and Advisories > Software ~ J-O ~ Documentation > NetWorker Family > NetWorker > 7.6 & Service Packs
-Bobby