Skip to main content
Start a Conversation

Unsolved

This post is more than 5 years old

eger

8 Posts

36780

September 16th, 2008 17:00

5324 not reloading after reload command

I just updated my 5324 to the latest firmware and boot code as instructed by the PDF. However after I type 'reload' and confirm it just keeps spitting out "Shutting down ..." lines over and voer and nothing happens.

 

I can disconnect and reconnect fine and try again and same thing happens. Switch is still pasing traffic and operting normally. Just will not remotely reload. Now I am scared to power it down manually...

 

Is this a known issue? Is there anything I should be worried about now that I need to manually power cycle it? 

rehcjam

7 Posts

September 27th, 2008 11:00

Have you tried the reload command from the console?
A remote session will be disconnected and all you will see is "Shutting down ..."

eger

8 Posts

September 29th, 2008 15:00

If you read my post it clearly states that I did try to reload. I eventually had to pull the power to get it to reload. It came up fine and after the upgrade it would also reload from the command also. Not sure why this happened. But seems to be fine at the moment.

Was this post helpful?

View All

No Events found!

Top