5448 is missing commands

Question

When I try to configure a stactic route in the switch I get the following. I'm wondering if the image is corrupt except I have two of this model with the same trouble. aspswt1(config)# ip route x.x.x.x /24 x.x.x.x% Unrecognized command a listing of the commands shows: aspswt1(config)# ip  access-list          This command creates an ACL, which perform                       classification on layer 3 fields and enters to                       ip-access configuration mode.  default-gateway      Specify default gateway  dhcp                 Acquire IP address from DHCP server  domain-lookup        To enable the IP Domain Naming System  domain-name          To define a default domain names that the software                       uses to complete unqualified host names  host                 To define static host name-to-address mapping in the                       host cache  http                 Specify the HTTP server configuration  https                Specify the HTTPS server configuration  igmp                 Global IGMP configuration commands  name-server          To set the available name servers, use the ip                       name-server global configuration command.  ssh                  Global Secure Shell protocol configuration subcommands  telnet               Telnet server configuration Software is: SW version    2.0.0.46 ( date  14-Apr-2011 time  13:10:53 )Boot version    2.0.0.0 ( date  12-Nov-2008 time  12:56:52 )HW version    00.00.02

Dev Mgr · Answer

The 5400 doesn't offer routing. You'd have to get a 5500 or 6200 or higher.

Networking General

Was this post helpful?