Unsolved
This post is more than 5 years old
11 Posts
0
7604
August 1st, 2011 11:00
6248 stack - adding a 6248P
Firmware = 3.2.1.3 on the 6248s and the 6248P
An existing 6248 stack with 3 members. When adding a 6248P the g1-g48 ports are not activated. The documentation says to "re-activate" the POE ports. But there is no reference to the GUI or CLI commands.... would someone point me in the proper direction?
No Events found!
ckh0d0a
11 Posts
0
August 1st, 2011 14:00
GUI -> System -> General -> Power Over Ethernet
I'll reconnect the stacking cables and see what I get -
hans555
18 Posts
0
August 2nd, 2011 13:00
As long as the firmware and boot-code are the same, the PC6248P should join as member# 4 and all the port should be active.