Unsolved
This post is more than 5 years old
4 Posts
0
8393
December 21st, 2004 17:00
Can't Bind a new ACL
Hi,
I'm having an issue when trying to apply a new ACL to a 3324. The switch has an existing ACL bound to port 1/e1 only, it works great. I've created a second, somewhat different ACL and when I try to bind it to port 1/e2, or any other port I get the following error. This happens whether I am using the web interface or the CLI.
"Can't apply input Policy 0 because of HW resources lack"
Even after removing the original ACL I get the same error, I've reset the switch and also tried a different switch that is configured exactly the same with the same error occuring.
Also I've noticed that the ACE priority #'s keep increasing when I make changes to existing ACL's on all of our switches, even if I delete and re-create the ACL...
Any assistance is greatly appreciated
Lyle
Message Edited by lyle.l on 12-21-200401:35 PM
Message Edited by lyle.l on 12-21-200401:38 PM
Message Edited by lyle.l on 12-21-2004 01:38 PM
No Events found!
DELL-Randy
132 Posts
0
December 22nd, 2004 13:00
lyle.l
4 Posts
0
December 22nd, 2004 15:00
lyle.l
4 Posts
0
December 28th, 2004 20:00
I've finally gotten around to giving this a try. I completed the firmware upgrade to version 1.2.0.6, all went well. Confirmed that this is the currently running firmware. I still am unable to bind the new ACL to any port... tried both the CLI and web interface. I get the same error:
1 General error Unknown value Can't apply input Policy 0 because of HW resources lack.
Anything else I can try?
As I did earlier I've tried this on more than on switch with the same result.
Thanks,
Lyle