Can't connect to PowerConnect 3448 using the web interface

Question

Hi !   I can't connect to my switch by using the web Interface nor a telnet session. I got the following error   Access was denied due to one of the following reasons:1) There are too many users logged in   or2) The specified user name and/or password is incorrect   or3) The specified user has not been granted web administration privileges   I confirm that the username/password is good and no change has been made on the credential used.   However, i can  use the console port and manage the switch. When I do a show users I see 6 active http users.   Is there a way to disconnect them? I try to disable the http ip server feature and put it back on but without no result.   Dell tech told me to reset the switch but I just want to be sure that there is no other workaround possible.   Thanks.

cerbera_a84f2d · Answer

This might seem basic, but have you enabled web and telnet access...

console.enable

console#configure

console(config)# username xxxxxx password xxxxxx level 15

Assuming you have - given you can see active mgt sessions - then the only solution is to reboot the switch

Message Edited by cerbera on 03-12-2008 06:06 PM

noxentoperators · Answer

Yes, telnet and web access are enable. I guess that I have no choice and reboot the switch.

Networking General

Was this post helpful?