As we can check on Cisco switches the bandwidth utilization of the interface of last 5 minutes by using the command.

switch#sh int po 1
Port-channel1 is up, line protocol is up (connected) 
  Hardware is EtherChannel, address is 0064.4026.739a (bia 0064.4026.739a)
  MTU 1500 bytes, BW 4000000 Kbit, DLY 10 usec, 
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, link type is auto, media type is unknown
  input flow-control is off, output flow-control is unsupported 
  Members in this channel: Gi0/1 Gi0/2 
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:04:48, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 2000 bits/sec, 3 packets/sec
  5 minute output rate 2000 bits/sec, 3 packets/sec

The same bandwidth calculation i want to do on Dell switches.

How can we check the bandwidth utilization on the interface on Dell 6248?

Regards,
Mukesh Kumar
Network Engineer
Spooster IT Services