Unsolved
This post is more than 5 years old
10 Posts
0
33801
November 23rd, 2015 08:00
Command Voice in PowerConnect 3424P
Hi everyone,
I have a Dell SW (version 2.0.0.34, Type:PowerConnect 3424P) and now I need to configure a phone.
I'm surfing on Net in order to find information, because I don't have enable the command voice, however, I'm not clear how I do it.
The configuration about this:
interface ethernet e3
switchport general pvid 6
switchport general allowed vlan add 6
The VLAN configured is: 6
Please, somebody tell me what I do for configure it.
Thanks a lot.
No Events found!
johnAvi
10 Posts
0
November 23rd, 2015 12:00
Hi,
Just, the phone being plugged into the port but doesn't work. What can I do?.. I mean, the configuration is correct?
Regards
johnAvi
10 Posts
0
November 23rd, 2015 12:00
Hi,
Just, the phone being plugged into the port but it doesn't work. What can I do?.. I mean, the configuration is correct?
Regards.
johnAvi
10 Posts
0
November 23rd, 2015 12:00
Hi,
Just, the phone being plugged into the port but it doesn't work. What can I do?.. I mean, the configuration is correct?
Regards.
johnAvi
10 Posts
0
November 23rd, 2015 12:00
Hi,
Just, the phone being plugged into the port but doesn't work. What can I do?.. I mean, the configuration is correct?
johnAvi
10 Posts
0
November 24th, 2015 10:00
Hi,
Yes, we had had that configuration, but didn't work.
What behavior you are seeing
The telephone is on, but without signal.
How is VOIP setup on your network?
By Routers and Switches allowed voice vlan.
Anything more, What can I do?
Regards.
johnAvi
10 Posts
0
November 24th, 2015 10:00
Is VLAN 6 being used across the network as your Voice VLAN?
- Yes
Do you have a DHCP server handing IP addresses out to this VLAN?
- No
Do you have other phones plugged into different switches on the network that are working?
- Yes