Unsolved
This post is more than 5 years old
1 Message
0
790
July 8th, 2018 23:00
Connecting N1500 series using 10GbE uplinks
I have two N1548P switches that will be located on two floors, 120 metres apart. I will run a OM3 fibre cable to cover the distance and want to use the SFP+ ports to connect the two switches. I don't need them to be stacked, so am I correct in assuming I will just need to set one of the SFP+ ports (eg Te1/0/4) into Ethernet mode on each switch to get them to pass traffic?
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.2K Points
0
July 9th, 2018 10:00
Hi,
Yes, if you are not stacking them just have them in Ethernet mode and a trunk port that passes the appropriate VLANs.