Unsolved
This post is more than 5 years old
10 Posts
0
15787
Fast Link Enabled or Not?
Every time power is lost or disrupted from our Dell PowerConnect 5224, they seem to lose the enabled option for FAST LINK....located under SPANNING TREE then PORT SETTINGS....is there a reason? I haven't found any resolution with the firmware updates v2 and v3...they are currently configured with v1....Any help is greatly appreciated......
DELL-GregG
812 Posts
0
November 13th, 2003 20:00
Do you lose these settings only during a power disruption or does it happen when you reset/reboot the switch as well?
What procedure are you using to copy the running configuration to the startup configuration? If you are clicking Apply Changes in the web UI, it will only write to the running-config (RAM). To copy the running-config to the startup-config, you must use the "Copy Running Config to File" option on the System/Switch/Configuration page.
I tested one of our 5224s running 3.1.0.8 firmware with both STP and RSTP, and the configuration survived a reboot.
kelowna
10 Posts
0
November 14th, 2003 15:00
seanw65
6 Posts
0
November 23rd, 2003 00:00
kelowna
10 Posts
0
November 24th, 2003 16:00