This post is more than 5 years old
1 Rookie
•
15 Posts
0
39622
May 14th, 2014 09:00
Force10 S4810P not keeping changes
Hi All,
We have just acquire two Dell Force10 S4810P switches, i started to configure the first one and i encounter with following issues.
I downloaded manual for configuring the swtich and followed instructions.
I am trying to set management adapter ip or any other service parameters after few minutes the switch is going back to starting point config all setting disappear.
Now i am new with those switch's , maybe i missed something or doing something wrong
Please advice
Thanks
No Events found!
tbaror
1 Rookie
•
15 Posts
0
May 15th, 2014 02:00
Hi Daniel,
Yes i did , several times but the same
following firmware version and also bootvar >(something i am not familiar with)
Thanks
FTOS>show system
Stack MAC : 00:01:e8:8b:9f:cb
Reload-Type : jump-start [Next boot : jump-start]
-- Unit 0 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S4810 - 52-port GE/TE/FG (SE)
Current Type : S4810 - 52-port GE/TE/FG (SE)
Master priority : 0
Hardware Rev : 3.0
Num Ports : 64
Up Time : 18 hr, 37 min
FTOS Version : 8.3.12.0
Jumbo Capable : yes
POE Capable : no
FIPS Mode : disabled
Burned In MAC : 00:01:e8:8b:9f:cb
No Of MACs : 3
-- Power Supplies --
18:38:14: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DISCOVER: DHCP DISCOVER sent on Ma 0/0.
Unit Bay Status Type FanStatus
--More--18:38:15: %STKUNIT0-M:CP %JUMPSTART-5-DHCP_OFFER_REJECTED: Server IP address x.x.x.32 was previously rejected. ----------------------------------------------------------------------------
0 0 up AC up
0 1 absent absent
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
----------------------------------------------------------------------------
0 0 up up 6720 up 6720
0 1 up up 6720 up 6720
Speed in RPM
-- Unit 1 --
Unit Type : Member Unit
Status : not present
Required Type : -
-- Unit 2 --
Unit Type : Member Unit
Status : not present
Required Type : -
-- Unit 3 --
*********Bootvar***********
FTOS#show bootvar
PRIMARY IMAGE FILE = system://A
SECONDARY IMAGE FILE = system://B
DEFAULT IMAGE FILE = system://A
LOCAL CONFIG FILE = variable does not exist
PRIMARY HOST CONFIG FILE = variable does not exist
SECONDARY HOST CONFIG FILE = variable does not exist
PRIMARY NETWORK CONFIG FILE = variable does not exist
SECONDARY NETWORK CONFIG FILE = variable does not exist
CURRENT IMAGE FILE = system://A
CURRENT CONFIG FILE 1 = variable does not exist
CURRENT CONFIG FILE 2 = variable does not exist
CONFIG LOAD PREFERENCE = local first
BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist
Reload Mode = jump-start