Unsolved
This post is more than 5 years old
3 Posts
0
923
December 5th, 2017 13:00
Force10 to Themis IPMI Issue
I have a Themis server that runs integrated IPMI. Everything works fine when the power is on, however when the power is off, my Force10 will not supply power to the port in order to remotely power on the server. If I plug directly into the server, I can access the IPMI.
The config for the port is below
interface TenGigabitEthernet 0/37
no ip address
portmode hybrid
switchport
no shutdown
The port is tagged in one vlan and untagged in another.
Any help is appreciated!
No Events found!
mtdevelopers
3 Posts
0
December 6th, 2017 08:00
The Dell Switch is a Force10 S4810 and the Themis server is RES-XR4-HD. The IPMI does support remote power on and does not need POE to work. I have plugged a regular household linksys switch and also directly into it and both work fine. Its something that the S4810 is not powering on the port.
mtdevelopers
3 Posts
0
December 6th, 2017 11:00
It gives me an error that the port is not in layer 3 mode. I tried to disable switchport to assign an ip however it makes me remove the interface from both the tagged and untagged vlans. Both of which I need it to be in,