This post is more than 5 years old
1 Rookie
•
33 Posts
0
1018
May 5th, 2020 07:00
MLAG Validation
I want to validate my MLAG config. The instructions reference A.1 and running the 'show vpc brief' command and the 'show interface port-channel x' command. I don't have any Cisco equipment, so I didn't run any of the vpc commands to configure MLAG so the 'show vpc brief' command doesn't show anything. The 'show interface port-channel x' command shows Active and the ports listed. Is this enough to validate?
0 events found
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.1K Points
0
May 5th, 2020 11:00
Hi,
Yeah that sounds fine.
ayaanamin
2 Posts
0
May 8th, 2020 07:00
Thanks, alot man because of you I got the solution.
ayaanamin
2 Posts
0
December 2nd, 2020 09:00
You can check out this article, and can also give your reviews on it and comment below 9 Ways to Fix 0x80070035: The Network Path Was Not Found
DELL-Tim G
4 Apprentice
•
73 Posts
0
December 3rd, 2020 07:00
Just for reference our MLAG guide is including all infos you need:
https://downloads.dell.com/solutions/general-solution-resources/White%20Papers/Using%20MLAG%20in%20Dell%20Networking%20N-Series%20Switches%20v1.5.pdf