Unsolved
1 Rookie
•
15 Posts
0
493
August 23rd, 2020 14:00
MXL and flow control
Looking a best practices I see its recommended to turn on flow control end to end for my storage network. I am unable to do this on my MXL. When I attempt it tells me that PFC is already on the interface. The only way I can see to turn in off it so turn on DCB and set the policy to not use PFC and them apply that to the interface.
How would I turn on flow control or is un-configured PFC the same as FC?
0 events found
No Events found!
Dell-DylanJ
6 Operator
•
2.9K Posts
0
August 24th, 2020 12:00
Hello,
You should find the manual of some use with this issue, I'll link to it below.
https://dell.to/31pkVDC
According to the manual. "You cannot enable PFC and link-level flow control at the same time on an interface." The command "no pfc mode on" should turn it off. For details on flow control, I would refer you to page 537.