MXL port configuration for PS-M4110 storage array

Question

Dear All, I have to configure my Force10 MXL 10/40 GbE for PS-M4110 storage array. I have two PS-M4110 connected to ports 0/13 and 0/15. I have configured it in the following way. FTOS(conf)# no dcb enable FTOS(conf)# iscsi enable   Configuration of ports 0/13 and 0/15 (same) FTOS(conf-if-te-0/15)#sho con!interface TenGigabitEthernet 0/13 no ip address mtu 12000 portmode hybrid switchport flowcontrol rx on tx off spanning-tree mstp edge-port spanning-tree rstp edge-port spanning-tree 0 portfast spanning-tree pvst edge-port iscsi profile-compellent no shutdown I just need to know if these settings are okay. And do I have to configure iscsi target port (3260,860) ip-address (A.B.C.D) as well? if yes, then which IP is to be given here? group-IPaddress?

fazalerehmankha · Answer

Thank you Daniel. I really appreciate your prompt response. I have seen this guide and configured the switch accordingly.

fazalerehmankha · Answer

Thank you Daniel. I really appreciate your prompt response. I have now configured the switch accordingly.

Networking General

Was this post helpful?