N1548P - Error when applying two out ACLs

Question

I am trying to block bonjour for both ipv4 and ipv6, I have the following two access lists on the switch:    ip access-list deny-mdns 1000 deny udp any 224.0.0.251 0.0.0.0 exit ipv6 access-list deny-mdns6 2000 deny ipv6 any host ff02::fb exit I tried to use the following two commands on an interface config ip access-group deny-mdns outipv6 traffic-filter deny-mdns6 out  Whichever command I use first works, but then the second command gives me the error: console(config-if-Gi1/0/4)#ip access-group deny-mdns out console(config-if-Gi1/0/4)#ipv6 traffic-filter deny-mdns6 out Error! ACL is incompatible with ACLs already configured on this interface and direction. console(config-if-Gi1/0/4)# Or if I reverse the commands: console(config-if-Gi1/0/4)#ipv6 traffic-filter deny-mdns6 out console(config-if-Gi1/0/4)#ip access-group deny-mdns out ACL is incompatible with ACLs already configured on this interface and direction. console(config-if-Gi1/0/4)# If I apply the same two ACLs for in it works fine no matter which command I put first: console(config-if-Gi1/0/4)#ipv6 traffic-filter deny-mdns6 in console(config-if-Gi1/0/4)#ip access-group deny-mdns in console(config-if-Gi1/0/4)# I'm not sure what else to try, any thoughts?

DELL-Josh Cr · Answer

Hi, What is the firmware version? Are these the only ACLs on the switch? Will it let you configure it from the web gui? I don’t see anything that says there is a limitation on egress acls on a single port.

Networking General

Was this post helpful?