thanks for ur reply

ssh telnet and http are enabled in my switch. as i am able to login using telnet to the switch. i am able to login using http (web console) also!!

show run shows the following output:

username "admin" password 3a9849218988fee7220ac49ad92155dd privilege 15 encrypte
d
username "auser" password 3a9849218988fee7010ac49ad92155dd privilege 15 encrypt
ed
username "root" password 3a9849218988fee7234ac49ad4312dd privilege 15 encrypted
line telnet
enable authentication enableList
exit
no iscsi enable
sflow 1 destination owner 1 notimeout
sflow 1 destination 192.168.50.99

console#show authentication methods

Login Authentication Method Lists
---------------------------------
defaultList : none
networkList : local

Enable Authentication Method Lists
----------------------------------
enableList : enable none
enableNetList : enable

Line Login Method List Enable Method List
------- ----------------- ------------------
Console defaultList enableList
Telnet networkList enableList
SSH networkList enableNetList

HTTPS :local
HTTP :local
DOT1X :

am i missing anything? i still face the same issue when i try to discover my switch using telnet/ssh/http

If i want to use telnet/ssh for a PC7048 switch, do i have to club it with SNMP? will just using telnet not work.

I assigned level 15 to a user admin

So do i still have to enter something in the

Enable ID

Enable Password

sections?

i am able to telnet into the switch from command prompt and from web browser. but simply cannot make this OMNM work with telnet

I'm having the same problem, what did you change on the SSH configuration of the switch to get this working?

Regards

Adrian

Same problem here, it's a pity that it lacks a good manual and a Dell technical who knows how to use it.

Hello All,

I am in the same situation. PowerConnect 7048 - I can Telnet, SSH and manage via Web interface but no joy on adding it to OpenManage network. Get error..

Did not respond to authentication. I have tried all the PDF's in terms of configuration but no joy. Anyone else have ideas ?

I have the same problem here. I can't discover my powerconnect in onm. I can ssh go enable but onm can't access to the switch

We still have no solution, but we have stopt putting time in this project.

I would recommend contacting dell through Twitter @dellcarespro

All,

The documentation on this software is terrible. Note that by reading a variety of posts, it now makes sense how to allow discovery.

1. Make sure SNMP is configured properly on both the switch and OMNM (or OME). If SNMP is not configured properly, discovery will not happen.

2. Configure SSH authentication methods, users, etc. on the switch.

3. When doing discovery set SNMP as the first method and then SSH as the second method.

After doing the above an "Inspect" was success and then discovery worked fine.

I hope that helps!

I agree.  This product is unecessarily cumbersome.  We use SolarWinds and I can discover multiple devices in 1/4 of the time it has taken me to test this.  That being said if I can get this working I might keep it running for the sake of getting additiional performance data from my F10 switches.

I'm running this on SVR2012.

When I attempt to discover the switch it says it can't login.  I'm discovering with SNMP and Telnet.  We don't have SSH enabled on the switches.  Perhaps it doesn't work without SSH.

At one point I wondered if it required the OS clients in order to login, so I added the following features:

SNMP

Telnet Client

TFTP Client

Didn't fix the problem, but I still need to reboot.  Would like to get this working but not willing to spend too much more time doing so.  Any hints is appreciated.  Network discovery with valid SNMP should be piece of cake.  If this product isn't able to do that there is a design problem.