OpenManage Network Manger 6.1

I install the OMNM 6.1 software in a company to more easily administer the switches . At first , I managed to synchronize the switches that communicates with software, but I can not have details on the switches, not even details . (no CPU, no memory usage  , no temperature, )

Can you help me , please ?

Thank you for your help, I watch the powerconnect type switches .

Dell powerconnect 3424 ,Firmware: 1.0.1.01

Dell PowerConnect 5548 ,Firmware: 1.0.0.14

Thank you for your help .

I'm sorry I gave you the wrong firmware , this is actually the 2.0.0.34 release. For testing on this software I managed to make the discovery of my switches, however I still can not to have details such as traffic flow , no graphics are displayed, I can not see data which transiste on different ports.

Voici quelques capture d'écran du logiciel OMNM

Traffic Flow

Performance

Authentification SNMP

Equipement

I want to backup my configuration and can be restored, can you tell me how?

je souhaiterais faire une sauvegarde de ma config et pouvoir la restaurer , pouvez vous me dire comment faire ?

I have another problem on the interface web ,

The first message : "Application server is currently not responding or is not fully initialized"

The Second :"Error communicating with Application server: 192.168.1.121:8089"

I created another virtual machine to continue to move except on the home page , but  i have another problem

The first message : "Application server is currently not responding or is not fully initialized"

The Second :"Error communicating with Application server: 192.168.1.121:8089"

Hi

I suspect the server hasn't initialized and started correctly; in the toolbar icons, you should have the app server icon, and it should have a green flag; it its red or yellow then the server isn't running.

Try deleting the VM and set up a new one( with a reasonable amount of CPU, and at least 8Gb memory)

Disable any AV app, and switch off windows account control.

Install Flash, ActivPerl & Java(before you try to install OMNM)

Once that's done, try and install OMNM; once the load has finished, you should see the appserver icon appear, and after about 10 minutes go green - you are then ready to go.

To get full discovery, OMNM uses SNMP and SSH/Telnet, so you need to enable both on the switches, and configure the authentication details for SNMP AND telnet/SSH in the discovery profile. Before you do a full discover, use the Inspect option; if it doesn't run 100% clean, then you need to correct the error first - this is usually an authentication mismatch

Good Luck