Unsolved
This post is more than 5 years old
13 Posts
0
14077
October 21st, 2005 21:00
Port Based Authentication: Admin Interface Control Usage
This is also known as
dot1xAuthAuthControlledPortControl in SNMP.
The problem is, I can disable a port (g9, specifically) using this field with forceUnauthorize so that ping no longer goes through the port. However, when I try to reenable using forceAuthorize, ping still does not work even though the field now shows forceAuthorize. This same technique works on another vendor's switch. I have to reboot the switch to get it to work. Am I using this wrong or is there a problem in the firmware?
No Events found!
DELL-Cuong N.
1K Posts
0
October 26th, 2005 20:00
When you forceAuth on the port did you read back the associated status to see what it was? Can you tell me what "dot1xAuthAuthControlledPortStatus" say after you forceAuth the port?
Cuong.
nlnoll
13 Posts
0
November 2nd, 2005 20:00
nlnoll
13 Posts
0
November 3rd, 2005 14:00
DELL-Cuong N.
1K Posts
0
November 3rd, 2005 14:00
Hi can you tell us which switch you observed this problem on? We would like to try to reproduce it.
Thanks,
cuong.
DELL-Cuong N.
1K Posts
0
November 15th, 2005 12:00
Just wanted to let you know that I reported this as a bug to the developing team. It will be fixed in a future release.
Cuong.