Powerconnect 8024f configuration

Question

Hi All, I have just acquired two powerconnect 8024f switches and a couple of dell servers. I am trying to implement into existing infrastructure. Currently I have PFSENSE appliance as firewall. I have set up new vlan for severs and switches to live on and assigned the interface an ip address of 192.168.2.254. I have ran setup on first 8024f switch and given it an ip address of 192.168.2.1 and set the default gateway to 192.168.2.254. I have enabled DHCP server on this range as well. Currently when I connect a client to the switch they are given an IP address and can ping the 8024f switch but cant ping the firewall or get access to the internet. I have the exact same setup on another network and it works well. Only difference is it is ubiquity gear. Can anyone point me in the right direction?

DiegoLopez · Answer

Hello @Mirage88, What firmware version do you have on the 8024f? Did you followed any guide for the configuration? Did you check the if the PFSENSE appliance is correctly configurated? Regards.

Networking General

Was this post helpful?