Unsolved
This post is more than 5 years old
7 Posts
0
29587
November 25th, 2013 12:00
Powerconnect2824 Managed Mode Problem
Hello,
I've the following problem with my switch.
I get the following error in managed mode.
%OS-F-MEMORY: OSMEMG_rn_free: Memory magic is invalid
******FATAL ERROR *****
Reporting Task: POLI.
Software version: 1.0.0.42 (Date 17-Feb-2011 time 13:52:08)
0x143b64
0x141144
0x5295c0
0x35691c
0x35a394
0x52dae0
0x49feb0
0x5cb7f8
0x5cc064
x05cc2bc
0x4a3180
---------------------
Then the switch resets and booted again. (Reloop)
If i clear the config to go to unmanged again the switch is working. If i press the managed modem. Set ip adress en click on Apply.
the same error apears.
0 events found
No Events found!
ronaldbronsink
7 Posts
0
November 26th, 2013 00:00
Dear Daniel,
I've updated the firmware again to the last version 1.0.0.45. It doesn't matter Same error occures. Ive also erased config en startup-config.
I Think it has something to do with snmp in combination with memmory. Is it possible to the clean the whole memory and disable everyting of SNMP?
Or do you want me to do something difference?
With Kind Regards,
Ronald
ronaldbronsink
7 Posts
0
November 26th, 2013 08:00
Daniel,
i've already done that.
Ive cleared config and startup-config.
It doesnt make anny difference.
In unmanged mode the switch works well if i go back to managed the same problem.
ronaldbronsink
7 Posts
0
November 26th, 2013 10:00
It is a standalone now on my desktop so nothing is plugged in except the Console cable.
Is it not possible to disable it trough debug console?
I can access the diagnostic menu what do you want to know?
ronaldbronsink
7 Posts
0
November 26th, 2013 13:00
hmmm nope.
I get the same error again with firmware version 1.0.0.45
---EDIT----
I get an other error.
%OS-F-TIMER: OSTIMG_timer_start: Timer's magic is illegal
---EDIT---
Cleared config and the same error as previous postings is back
ronaldbronsink
7 Posts
0
November 26th, 2013 13:00
Ive downgraded to software version 1.0.0.33. Now the switch is working again.
I can now acces the web page.
What should i do? Stay @ this version or try to update to 1.0.0.45 again?