Unsolved
This post is more than 5 years old
1 Rookie
•
18 Posts
0
2979
September 12th, 2018 06:00
Remove stack in N1500 series
Hi All,
We used two N1524 switch for stack using DAC cables. Stack got successfull.
But when we reboot the member 2 switch, after the reboot connected users cannot reach the network ? It is only for member 2 switch. What is happening there ? Anyone has any input regarding that.
And 2nd question is how do you remove the stack, we poweroff the switch and remove the dac cable then power on and apply no member command. But still it shows stack member as two. Any wrong in the configuration
0 events found
No Events found!
prashanma
1 Rookie
•
18 Posts
0
September 13th, 2018 02:00
Thank you Daniel, so according to PDF u shared, it says that we need to "Remove all the member ports of any Port-Channels (LAGs) so there will not be any control traffic destined to those ports connected to this member."
So i need to remove following commands according to manual.
interface Te1/0/3
channel-group 10 mode active
exit
!
interface Te1/0/4
channel-group 10 mode active
exit