Start a Conversation



5 Posts


October 23rd, 2023 22:59

RSPAN - Dell N2000 switches

Just a quick simple (hah!) question I am hoping you guys can point me in the right direction for. I'm setting up RSPAN across our switch environment for a new Security Solution being installed and as a test case I want to send traffic from ALL ports (different vlans may be setup on various ports) on a single switch back to the monitoring device a few switches away. I have seen the examples in the manuals and in various blogs of how to monitor a single port and a couple of ports but my question is - can you monitor a range of ports eg Ports Gi 1/0/1 - Gi 0/47 with port Gi 1/0/48 setup as the reflector port (uplink ports being the Te 1/0/1 and 1/0/2 ports) rather than adding every single port to the monitoring session one at a time?


monitor session 1 source int gi 1/0/1 both
monitor session 1 source int gi 1/0/2 both
monitor session 1 source int gi 1/0/3 both

and so on down to

monitor session 1 source int gi 1/0/47 both

Can I accomplish the same thing by using something like 

monitor session 1 source int range gi 1/0/1-47 both  or similar ??




3K Posts

October 24th, 2023 03:47



Unfortunately, you will not be able to use range command. 

No Events found!