setup trunk encapsulation on PowerConnect 3324

Question

hi everyone howto setup: switchport trunk encapsulation dot1q on PowerConnect 3324 ? kind regards anonimous Message Edited by anonimous on 06-29-2007 09:24 AM

bh1633 · Answer

console(config)# vlan database
console(config-vlan)# vlan 101,102,310
console(config-vlan)# exit

console(config)# interface Ethernet e16
console(config-if)# switchport mode general
console(config-if)# switchport general allowed vlan add 101,102,310 tagged
console(config-if)# switchport general pvid 4095
console(config-if)# exit

bh1633 · Answer

You have to add vlans to the trunk on the 3324.   console(config-if)# switchport trunk vlan add 101,102,310   (this is from memory, so syntax may be slightly off).

krolk · Answer

on Cisco Router I have:

# interface XXXXX
# switchport trunk encapsulation dot1q
# switchport mode trunk

I've setuped on PowerConnect 3324:

(config)# interface ethernet 1/g1

(config-if)# switchport mode trunk

(config-if)# exit

is it my dell configuration OK ?

Message Edited by anonimous on 06-29-2007 10:20 AM

Crzywolf · Answer

close.   switchport trunk allowed vlan add x,x,x,   the port will keep VLAN 1 as its native VLAN.  The native VLAN is where all untagged traffic gets dumped into.

Networking General

setup trunk encapsulation on PowerConnect 3324

Was this post helpful?