I managed to stump myself with some networking. Long story short I am trying to trunk all VLANs from one switch to another, but cannot seem to make it work. One switch is a Dell PowerConnect, the other is a Dell Force10. Same vendor different model, so it should work.
I can see that the connection is active, line state is up, VLANs report they are active, the cable has been tested, but I cant seem to ping from one switch to the other. Any pointers? Steps I missed?
Interfaces:
console# show interfaces configuration ethernet g23
Flow Admin Back Mdix
Port Type Duplex Speed Neg control State Pressure Mode
-------- ------------ ------ ----- -------- ------- ----- -------- ----
g23 1G-Combo-C Full 1000 Enabled Off Up Disabled Auto
and
Force10#show running-config interface gigabitethernet 0/43
!
interface GigabitEthernet 0/43
no ip address
switchport
vlan-stack trunk
no shutdown
Switchport:
console# show interfaces switchport ethernet g23
Port : g23
Port Mode: Trunk
Gvrp Status: disabled
Ingress Filtering: true
Acceptable Frame Type: admitAll
Ingress UnTagged VLAN ( NATIVE ): 1
Protected: Disabled
Port is member in:
Vlan Name Egress rule Port Membership Type
---- -------------------------------- ----------- --------------------
1 1 Untagged System
10 client private Tagged Static
20 server private Tagged Static
and
Force10#show interfaces switchport gigabitethernet 0/43
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
Name: GigabitEthernet 0/43
802.1QTagged: True
Vlan membership:
Q Vlans
M 10,20,
VLANs:
console# show ip interface vlan 20
Gateway IP Address Activity status Type
----------------------- ----------------------- --------
IP Address Type
----------------------- ---------
10.0.0.2/16 Static
and
Force10# show running-config interface vlan 20
!
interface Vlan 20
description Server Private
ip address 10.0.0.9/16
vlan-stack compatible
member GigabitEthernet 0/43
no shutdown
You might want to review the configuration manual for each switch. To simplify, based on your description, you might want to check these configurations guide for PowerConnect and Force10 switch on their port modes:
DELL-Joey C
Moderator
•
4170 Posts
•
20965 Points
279
0
Posted August 9th, 2022 22:00
Hello @judahnator,
You might want to review the configuration manual for each switch. To simplify, based on your description, you might want to check these configurations guide for PowerConnect and Force10 switch on their port modes:
Force10 switch: https://dell.to/3zDnCkU
PowerConnect: https://dell.to/3zKDYbA
DELL-Joey C
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’ if I did.