What's wrong with this interface range? (Invalid input)

Question

This is driving me nuts!  I can't figure out what is wrong with this range command. field-switch(conf)#interface range gi 1/3-4, gi 2/3-4 ^ % Error: Invalid input at '^' marker. The interfaces do all exist. field-switch(conf)#int gi 1/3 field-switch(conf-if-gi-1/3)#int gi 1/4 field-switch(conf-if-gi-1/4)#int gi 2/3 field-switch(conf-if-gi-2/3)#int gi 2/4 field-switch(conf-if-gi-2/4)#

DELL-Josh Cr · Accepted Answer

Try field-switch(conf)#interface range gi 1/3 - 1/4, gi 2/3 – 2/4

DELL-Josh Cr · Answer

Hi, Which model switch is it and what is the firmware version?

NoOneOfConsequence · Answer

It's an S3048-ON (actually a stacked pair), running FTOS 9.10(0.1).

Networking General

Was this post helpful?