2 Posts
0
160
DELL INSPIRON 24 5490 27 7790 INTEL CORE I5-10210U CPU DESKTOP MOTHERBOARD 3YJM6
Can i use this Dell Inspiron 24-5400 27-7700 IPTGL-CL i7-1165G7 Motherboard 0VY7G1 to replace a
DELL INSPIRON 24 5490 27 7790 INTEL CORE I5-10210U CPU DESKTOP MOTHERBOARD 3YJM6
given that the processor is built into the motherboard and are the same model just a different processor ?
redxps630
7 Technologist
7 Technologist
•
10.5K Posts
0
November 15th, 2023 05:44
Note also there is a socket on 3yjm6 top Right next to cmos battery, but vy7g1 does not have it. another mismatch. definitely no.
redxps630
7 Technologist
7 Technologist
•
10.5K Posts
0
November 15th, 2023 05:38
That is a close call. I was almost going to give a green light but no, the board has different proprietary form factor.
the layout is nearly identical, I will give u that.
https://www.ebay.com/itm/126155953135
https://www.ebay.com/itm/126101029070
redxps630
7 Technologist
7 Technologist
•
10.5K Posts
0
November 15th, 2023 05:40
3yjm6 board Right edge is straight
Vy7g1 board Right edge is stepped.
in general you can hardly put a different AIO model board in another pc. They are like laptops.
Yardieman
2 Posts
0
November 15th, 2023 17:49
@redxps630 Thank you for taking the time to point out, the difference.
Mike1788
1 Rookie
1 Rookie
•
54 Posts
0
November 16th, 2023 18:30
@Yardieman I did a little research and the newer Inspiron 5400 board with the 11th gen Intel will 100% fit. There's space where the board is slightly extended by the CMOS battery but there's an empty space there between the fan. The cover/shield looks like it MIGHT fit in the corner with the protrusion - hard to eye it 100%. If it's slightly too narrow there, the corner is already slit and perforated in that area so you could either cut off a small sliver of metal or just bend the cover outwards slightly as there's plenty of clearance and it's not attached near that corner nor is the cover structural at all or even necessary, really.
So, it's a direct replacement that may require bending a small metal tab at worst. Seems the newer 5400 boards are way cheaper and more common on ebay than the 5490s. If it looks like it'll fit, it almost always will as Dell and everyone else tends to want to not change part production for a single different piece.