Error message in boot sequence (BIOS related ?)

Question

Since my PowerEdge 1800 server had its motherboard replace, when i boot the server it stop at this message: Strike F1 to continue, F2 for the setup utility.   If i strike F1 the server boots normally and runs perfectly.  If i go in F2 there seems to be nothing acknowledge.  Everything is as it should be.   Any idea to get rid of this annoyance ?   Thanks

AXI · Answer

does this system have a raid controller in it?? is so you may need to change the boot sequence in the bios so that it boots off the controller not the bios boot devices.....

PowerEdge Hardware General

Was this post helpful?