iDrac 9 snmp temp OIDs

Question

Hi, I have imported a lot of OIDs for our iDrac 9 on our R640, but actual temp readings through SNMP seem to be absent. I can get probes reporting UP or OK, but whether I try an import (this is on PRTG) or manually add the OID listed here: https://www.dell.com/support/manuals/en-uk/idrac9-lifecycle-controller-v3.3-series/snmp_idrac_cmc_9.3_ref_guide/chassis-status?guid=guid-669fbb93-9fdb-4171-bf89-ab7bfedea4bf&lang=en-us

It reports that object is not found.

I'm sure I'm doing something obvious wrong, but I've gone through the settings I could find to ensure that snmp is properly enabled.

I'm not really a pro on the iDrac in general, only get into the interface when I rarely need to do something. So I could be overlooking something.

Appreciate any guidance.

APierce79 · Accepted Answer

Thank you, but these give error 222 no such object found on our server.

I did find from other places a couple that work, but not all. I don't know where these posters got this info though, so I don't know where else to look. https://www.dell.com/community/PowerEdge-Hardware-General/SNMP-OID-s-for-System-Board-Exhaust-Temperature/m-p/7837747

DELL-Charles R · Answer

Hello APierce79,

These may be the ones you are looking for. Page 36 from the pdf you have:

Table 151. DRsChassisFrontPanelAmbientTemperature

Table 152. DRsCMCAmbientTemperature

Table 153. DRsCMCProcessorTemperature

Dell-Dheeraj · Answer

Unfortunately, I couldn't find any Dell articles that may help you with this, but found these below articles which may assist you.

Let me know if it works.

PowerEdge Hardware General