Unsolved
This post is more than 5 years old
1 Rookie
•
40 Posts
0
1920
July 16th, 2019 05:00
PowerEdge R210 II
Hello. I have a question regarding older server PowerEdge R210 II. As per manual there is no Idrac port by default only IPMI port on same interface as eth0. Is there any way we can modify it. something like to mport iDRAC card/ port? Thank you
No Events found!
Dell-DylanJ
6 Operator
•
2.9K Posts
1
July 16th, 2019 07:00
Hello,
https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-r210-2_owner%27s%20manual_en-us.pdf
On page 116 of the manual, you'll see a diagram of the motherboard. Connectors 4 and 5 are the relevant ones. Connector 5 is where the iDRAC Express would need to be installed. Connector 4 is where you can connect the iDRAC Enterprise card. Keep in mind that to use the iDRAC Enterprise, you would also need the iDRAC Express module installed.
The iDRAC Express module part number is JPMJ3. The iDRAC Enterprise part number is J675T.
wangyuhang
3 Posts
0
November 25th, 2021 00:00
I have this spare part number of the module and card, after installation can not boot. Is it my firmware version