Unsolved
This post is more than 5 years old
4 Posts
0
20825
November 15th, 2012 11:00
Dell R410 Raid adapter Memory error!!
I am currently having a problem with my server Raid adapter that displays the following error (Raid adapter memory error!) Then you perform an update to the same controller, displays this error and I do not initiate the discs.
If you have any possible solution please let me know in this forum or email me at [ADMIN NOTE: Email address removed per privacy policy]
No Events found!
theflash1932
11 Legend
•
16.3K Posts
0
November 15th, 2012 11:00
Which "RAID adapter" are you using?
anthonycruz13
4 Posts
0
November 15th, 2012 12:00
The RAID adapter is PERC 6/i
theflash1932
11 Legend
•
16.3K Posts
0
November 15th, 2012 12:00
Power off. Remove the controller. Disconnect the battery cable. Remove the memory module. Re-insert the memory module. Reconnect the battery cable. Re-insert the controller. Power on and see if you still get the same message.
If so, clear the NVRAM using the jumpers on the motherboard. If you still get that error, then the memory module on the controller most likely needs to be replaced, but it may be the controller itself, although less likely.
anthonycruz13
4 Posts
0
November 15th, 2012 12:00
the RAID adapter is PERC 6/i
anthonycruz13
4 Posts
0
November 16th, 2012 05:00
Can you send me an instruction to clear the NVRAM on my server? Because i do not have the manual user!
theflash1932
11 Legend
•
16.3K Posts
0
November 16th, 2012 07:00
Page 169:
support.dell.com/.../HOM.pdf
Move the jumper from the last two pins (3,5) to the first two pins (1,3), then boot ... once you see a message about the NVRAM jumper, then power off, place the jumper back, then boot up.