Unsolved
This post is more than 5 years old
2 Posts
0
4975
September 4th, 2005 14:00
Raid configuration
I had in my server RAID-1 with two HD.
I removed as the secondary HD of the Raid-1.
after that I placed again.
After this I placed as the HD and I set in motion the command again To reconstruct in the BIOS of the PERC4.
However during the reconstruction I defined the RAID as 0, I initiated the system with the HD I contend the old installation.
After this I initiated the system with the first HD only and the system beginning without problems.
I initiated a new installation in the new HD.
After this I did not initiate more the system with the two HD.
When I initiated the two together ones again, the installation that went up was the new.
My question is, the information of the old installation had been extinguished when the system was initiated?
I do not say English
I am only improvising, forgives for the errors
0 events found
No Events found!
warwizard55
720 Posts
0
September 4th, 2005 16:00
Renato-Americo,
As far as I can tell, you have destroyed your previous array info, perhaps the Dell technicians can help get it back.
Good Luck.
warwizard DCSP
renato-americo
2 Posts
0
September 4th, 2005 19:00