You can do it from the CTRL-R utility during POST, or you can do it in OMSA ... under Storage, click on PERC 5, Information/Configuration (link at top of page), then select Create/New from the dropdown menu of Available Tasks for the controller (you can also access it by going to the Virtual Disks screen and clicking on the new VD wizard link).
theflash1932
9 Legend
•
16.3K Posts
0
May 16th, 2014 07:00
You can do it from the CTRL-R utility during POST, or you can do it in OMSA ... under Storage, click on PERC 5, Information/Configuration (link at top of page), then select Create/New from the dropdown menu of Available Tasks for the controller (you can also access it by going to the Virtual Disks screen and clicking on the new VD wizard link).
JBH404
3 Posts
0
May 16th, 2014 07:00
Very cool...but I think this older machine is not setup properly as my drop down doesn't contain the "Create New" selection:
I see that the firmware needs to be updated but is this stopping my ability to create the RAID 0 for my single disk?
Thanks,
JBH
JBH404
3 Posts
0
May 16th, 2014 07:00
Funny enough...I was able get this to work using the wizard!
Thanks for all your help!!!
JBH