utility partition not available error message

Question

I am trying to configure the Poweredge 2600 raid perc 4/di LSI Logic. I only get utility not available message. And when I try to boot to the diagnostic by hitting F10 on boot up I am unable to do so. I still get the same message.

How do you do the Raid containers in the LSI Logic
Configuration.

I need help...

Techhcet · Answer

Ctrl + M is the keystroke you should use when trying to setup the Raid.
You should see this mentioned in the post when it recognises the perc controller.
If it does not, check in the system bios to see if Raid is enabled.

ardge · Answer

I already did go to PERC BIOS . Configured 1Logical Hard Drive and Initialized. My problem was after it. It's got LSI Logic COntroller. I know in Adaptec Controllers you press Ctrl+A to build containers. How can I build containers in LSI Logic RAID controllers? I think that should have been my question.

Techhcet · Answer

Sounds like you already have, if you have entered the perc bios and created a logical drive. Your logical drive is the same as the containers in adaptec, just a different way of describing them.

PowerEdge HDD/SCSI/RAID

utility partition not available error message

Was this post helpful?