Solved!
Go to SolutionPP 5.1.0 cannot see any devices
Hi,
Can somebody help me. On hpux 11.11 connected to DMX1000 by 4 FCs
I can not see any device after cmd powermt display dev=all I get message
Device(s) not found. My license is valid. So my server is running over one path.
Best regards OLI
Can somebody help me. On hpux 11.11 connected to DMX1000 by 4 FCs
I can not see any device after cmd powermt display dev=all I get message
Device(s) not found. My license is valid. So my server is running over one path.
Best regards OLI
419
0
Posted February 19th, 2008 07:00
1. Can the OS see the devices? Can you paste up the output of ioscan -fnkC disk
2. Did you run powermt config
Thanks
CB389
0
Posted February 19th, 2008 07:00
blazing fast SMTP servers here389
0
Posted February 19th, 2008 07:00
beat me to it dynamox!389
0
Posted February 19th, 2008 07:00
did you run ioscan and insf before your tried powermt config ?419
0
Posted February 19th, 2008 08:00
Hi,
ioscan is OK, It seems server is running over path defined in lvm..
I have second server, same HW, same OS and there is all OK..
File powermt.custom is more smaller on wrong server.419
1
Posted February 19th, 2008 08:00
so from ioscan -fnC disk ..you can see the HW path , but when you run powermt config and powermt display ..nothing displays ? Do you have inq or syminq on the box ?419
0
Posted February 19th, 2008 10:00
Hi Oli,
Do you have any other path fail-over software configured?
Did you just install PowerPath? What version?
From the ioscan output are all paths (presume you want to see 4 paths?) displayed? Are all devices in a CLAIMED state?389
0
Posted February 19th, 2008 23:00
Hey, you get an email saying there's new content on the forum ? Can I have that too ?270
0
Posted February 20th, 2008 00:00
Hey, thanks !
Perhaps now I can beat Stefano for once
xe2sdc
6 Operator
•
2831 Posts
670
0
Posted February 21st, 2008 01:00