Dell Powervault 650F hangs on boot... Panic Code 0x000000E7 HELP!

Question

When I power up the Dell 650F powervaul with hypertermianl on the console port. This is what i get. Any Ideas?   Copyright (c) CLARiiON Storage Systems, Inc. 1991 - 1999Disk Array Subsystem ControllerModel FC5600CFirmware Revision 03.21 - Aug 13,1999 ABCDEabFabcdefgGabHabcIJKLabMabNOPabcQabc Verifying Firmware Revision... Initializing Back End Fibre... .... Storage System Failure - Contact your Service Representative ... Information Code 0x000000E7   Thanks in Advance.

bvanbeusichem · Answer

Do you have the same problem when the fiberconnectors are disconnected from the Storage Processor boards?

If not there is an problem with (one of) your server configuration (drivers etc).

I have seen this once at an customer who installed the wrong version of management software on 1 server in the SAN.

WarlockNZ · Answer

you need the Flare code on your disks my friend

PowerVault

Was this post helpful?