Unsolved
1 Message
0
392
November 17th, 2020 19:00
PowerVault MD3200i Raid 10 Raid rebuild but data is not complete
Hello,
We have an PowerVault MD3200i - 8 ports. It has a failure on disks 4 and 5. Disk 4 was able to recover, so we only replaced Disk 5. Now the RAID has been recovered but data is not complete. If we do a "df -h" command, we got the same "TB used" before we had the issue.
Any ideas would be appreciated.Thank you.
No Events found!
DiegoLopez
4 Operator
•
2.7K Posts
0
November 18th, 2020 07:00
Hello @rodrigo.Andrade09,
Are there any errors on the MD if you connect via MDSM? What about the firmware versions? are they up to date?
Did you follow this procedure for replacing the disk:
Replace a disk in predictive or impending failure on PowerVault MD32XX – MD36XX
Looking forward to your answer.
Regards.