Unsolved
1 Rookie
•
4 Posts
0
558
June 13th, 2022 12:00
T1700 battery and power on issues
Hello.
Idk if it happened to anybody. Here is what my 48DY8 motherboard does.
When I plug in the computer it will begin the boot sequence 3 times.
Led comes up fan speedup, waits 7 seconds, reboot,
led comes up, wait 7 seconds fan speedup, reboot,
led comes up and it boots to F1 prompt because of date setup, I press F1 and it boots.
If I put a working battery in the motherboard the system wont turn on. Not a blink on the leds. Nothing.
Anybody?
No Events found!


bradthetechnut
9 Technologist
•
9.6K Posts
•
40.6K Points
0
June 13th, 2022 17:00
Does it boot without a battery?
By any chance tested new battery or tried a different one? I use Duracell as they last around 5 years. Sony only lasted me 2 years.
I remember one user had a similar problem. This would be at your own risk. - User got the thing to boot and installed battery with PC turned on. Probably best to have thin latex/rubber gloves on.
A halfway decent PSU tester might not hurt if no luck with any of the above. PSU testers at Amazon
k.neo
1 Rookie
•
4 Posts
0
June 13th, 2022 19:00
Actually after turning the fans on and off 3 times it boots, fine. Mind you dead battery or no battery, as soon as I turn on my power strip it goes into booting without asking me.
Diagnostics only say about front usb not connected and chassis fan being at fault. Have 4 pin dell fans and heatsink fan is dell too.
Made my own power cable connector, leds light up. When powered on, the power button shuts off the computer, also turns it back on if I the psu is connected and supplying standby voltage.
All of that without battery.
Funny thing this motherboard apparently has another fan connector, the inlet fan , that usually goes in front, but the manual does not list it at all and it is not working even if a fan is connected to it.
If I put a working battery 2.8v it wont boot by pressing power button.
bradthetechnut
9 Technologist
•
9.6K Posts
•
40.6K Points
0
June 13th, 2022 19:00
So by "led" you meant you have led strips?
Only a couple of other things I can think of. 1. Battery should be 3.5v. 2. It boots by itself when power strip is turned on because that option is probably turned on in BIOS Power Management.
k.neo
1 Rookie
•
4 Posts
0
June 14th, 2022 18:00
You know the 2 leds on the 5 pin power cable. Those leds.
Gonna check those options in bios.