T5500 motherboard

Question

sorry for my English

I have trouble with the riser board that when I put this riser it won't run and the power button show orange color and number 234. After I take out the riser the computer still can run to window. May I know what is the problem with mother board or riser board? As the picture I taken from the motherboard I can see the hole on the leg of riser.

speedstep · Answer

memory configuration,  Latest bios, and matching processors and ram are all a requirement.

Sakovaio · Answer

Thanks let me try

speedstep · Answer

Dell Precision T5500 Memory Configuration The T5500 is a Single Processor system with 6 DIMM slots or a Dual Processor System with 9 DIMM slots if the optional expansion riser is installed. There are three memory channels, each managing two DIMM slots with one additional channel managing three DIMM slots if the riser is installed. The RISER DOES NOT WORK Without a processor and the CPUs must be exactly the same stepping and revision and part number.

You cant mix density and rank and speed and vendor and ecc vs non ecc.

https://downloads.dell.com/manuals/common/precision-t5500_setup%20guide_en-us.pdf

Specs: DDR3 PC3-12800 • CL=11 • Dual Ranked • x8 based • Registered • ECC • DDR3-1600 • 1.35V • 1024Meg x 72 •

Slots:6 (2 banks of 3)

Single Dual and Quad Rank ram cannot be mixed.

Quad Rank Ram is NOT SUPPORTED

HIGH Density Ram is NOT Supported.

dual cpu config is complex all ram should match vendor and speed at a miniumum

RAM CONFIGURATION

Sakovaio · Answer

This t5500 i never change anything. After the pc can not start up I open and take the riser board and insert back. I see my cpu riser 1 (cpu_RSR1) GOT AHOLE. LIKE THE PICTURE.

Precision Fixed Workstations

T5500 motherboard

Was this post helpful?