Unsolved
This post is more than 5 years old
1 Message
0
20681
June 20th, 2014 07:00
1235cn Heat Error then System Power
Got a beep while on standby. Display said something about a heat error (wasn't getting hot enough). Now says "system error cycle power." Shut it down, disconnected power cable & printer cable over night. Plugged back in - still system error cycle power. Removed every removable piece to my ability (toner, drum, etc. and re installed. No paper jams, nothing. Re-powered and still system error.
Any ideas?
No Events found!
DELL-Joey
5 Journeyman
•
336 Posts
•
1.6K Points
0
June 30th, 2014 09:00
Hello JEFF618,
The heat error relates to your fuser, usually that the right temperature is not reached. This can be caused by several factors, mainly that the unit does not have sufficient power so make sure to have the unit plugged directly to the wall.
For the system error, do you see a number sequence listed with the dispaly error?
Regards,
Joseph E
[tag:iworkfordell]