Unsolved
This post is more than 5 years old
10 Posts
0
602
June 19th, 2019 09:00
Can not access iRDAC6 during Boot
R610 service tag.
Updated BIOS from 3.0.0 TO 6.6.0 today successfully but can no longer access iDRAC6 config on boot. Like to know if there is a work around. Any suggestions would be welcome. iDRAC firmware was 1.7.
No Events found!
Daniel My
12 Elder
•
6.2K Posts
0
June 19th, 2019 12:00
Hello
I would try updating the iDRAC through the operating system. 2.92 appears to be the latest version.
http://www.dell.com/support/
http://www.dell.com/idracmanuals/
If the iDRAC is not loading at all then it cannot be updated. I suggest reviewing the release notes of all BIOS revisions between 3.0 and 6.6 to see if there were any stipulations about minimum iDRAC revision. Also, you should check for any limitations on back-flashing. Back-flashing the BIOS would be another step to try to get the iDRAC to load. If you can get the iDRAC to load by back-flashing then update the iDRAC and then update the system BIOS.
Thanks