Unsolved
This post is more than 5 years old
1 Rookie
•
1 Message
0
2417
May 15th, 2019 21:00
dell r710 server system board p fault fail safe: voltage sensor error
I have Dell power edge E 710 Server.It shows 2 errors on front panel display screen.Error 1 is System board 1.1 VPG :voltage sensor for board,state asserted was asserted.Error 2 System board P Fault Fail Safe: Voltage sensor for system board,system asserted was asserted.When i start this server only its front display working and showing errors.It is remotely accessible through iDRAC. Please help me to sort out this issue.
No Events found!
DELL-Chris H
7 Practitioner
•
9.7K Posts
•
48K Points
0
May 16th, 2019 06:00
Aseem Mowar,
You can start by draining the power from system by turning off the server, then pull the power chord and hold the power button in for 20 seconds to drain the remaining power off the server board. Reinstall the power cord and power up. Do this with each power supply individually in each slot to test. If you get the same error, you will most likely need to replace the motherboard.