The error message "expected netfn 7 cmd 24, got netfn 4 cmd 3d" indicates a mismatch in the expected and received IPMI commands. This typically happens when the system receives an unexpected command or response, which can be due to several reasons:
Firmware or Software issues
Configuration Problems
Network Issues
I would start with making sure the BIOS an iDRAC are up to date from the R510 support page:
Then I would also verify in the iDRAC - iDRAC settings- IPMI Settings that Enable IPMI over LAN is enabled and the privilege level limit, and if your authorization matches.
This resource should help:
*Configuring Your iDRAC6 page 42
*Configuring the Network and IPMI LAN Settings page 54
DELL-Charles R
Moderator
•
4.7K Posts
0
April 28th, 2025 18:58
Hello,
The error message "expected netfn 7 cmd 24, got netfn 4 cmd 3d" indicates a mismatch in the expected and received IPMI commands. This typically happens when the system receives an unexpected command or response, which can be due to several reasons:
Firmware or Software issues
Configuration Problems
Network Issues
I would start with making sure the BIOS an iDRAC are up to date from the R510 support page:
https://www.dell.com/support/product-details/en-us/product/poweredge-r510/drivers
Then I would also verify in the iDRAC - iDRAC settings- IPMI Settings that Enable IPMI over LAN is enabled and the privilege level limit, and if your authorization matches.
This resource should help:
*Configuring Your iDRAC6 page 42
*Configuring the Network and IPMI LAN Settings page 54
*Table 4-5. IPMI Settings page 59
*Configuring IPMI page 66
https://dl.dell.com/manuals/all-products/esuprt_electronics/esuprt_software/esuprt_remote_ent_sys_mgmt/integrated-dell-remote-access-cntrllr-6-for-monolithic-srvr-v1.2_user%27s%20guide_en-us.pdf